Bulk Fill Dirt Delivery in Mission, TX by the Ton
Bulk fill dirt delivered in Mission, TX. Brown color.
Starting from $469.04 delivered to Mission for 2 tons, our minimum order
Fill dirt delivery in Mission, TX is a practical choice when a yard, drive or garden bed needs more height than the existing soil can give. The material is sold by the ton and delivered to your address, so you can match the order to the area rather than hauling it in bags.
Where Fill Dirt Fits on a Mission Property
Homeowners in Mission most often use fill dirt to raise a low corner of the lot, fill a gap beside a walkway, or level ground before a new patio goes in. Contractors use it for backfill around footings and utility trenches, where the goal is a stable, even fill rather than a planting bed.
- Raising a low corner where water sits after a heavy rain
- Backfilling trenches for irrigation, drainage pipe and small utility runs
- Leveling a site before sod, pavers or a new fence line
- Building up a garden area that the owner will top with finish soil
Fill dirt is the bulk layer, not the finish. Around plants, Mulch, sold by the yard, covers the soil in beds once the fill is in place and the surface is even.
Local Overview of Fill Dirt Delivery in Mission
Mission is a city of about 89,000 people in the Rio Grande Valley. Warm weather for much of the year keeps yards growing and lots changing, so ground that looked level one season can need attention the next.
The nearby towns of McAllen (about 6 miles), Pharr (about 9 miles), Edinburg (about 13 miles) and Harlingen (about 39 miles) give a sense of how the valley is laid out. Mission itself is where most homeowners will set the drop point for their order.
Because Mission lots often sit close to neighbors and to alleys or service paths, owners tend to plan the fill to stay inside their own property line. Walking the site with a tape and a stake before you order makes that boundary easy to see, and it keeps the finished grade where you intend it to be.
Cities elsewhere in the state are linked from Fill Dirt in Texas. The general uses are the same across Texas, so the notes on this page focus on the Mission market and its typical jobs.
How Much Fill Dirt a Mission Project Needs
Start with the area in square feet, then decide how deep the fill layer should be in inches. For a Mission fill project, multiply length by width by depth in inches and divide by 324 to get cubic yards. Picture an 18 by 30 foot low corner raised 6 inches: that is 10 cubic yards, and at 2,200 pounds per cubic yard it weighs about 11 tons. Plan for some compression after the material is spread, and add a bit to the total so the finished grade is not short.
If you want a quicker estimate, the calculator is the fastest place to start before you place the order.
Delivery and Pricing for Fill Dirt in Mission
The delivery in Mission page explains the city service. The price shown for your ZIP is the delivered price, so you see the number that applies to your address. Bigger orders are billed at a lower rate per ton, and the smallest order is 2 tons.
Choosing Fill Dirt Among Other Options
Fill dirt is one of several bulk materials for Mission yards. Premium Screened Topsoil is the better pick when the goal is growing grass or flowers, while fill dirt is the bulk fill for the layer underneath. Some owners order both, one for the base and one for the top, and that split usually gives the cleanest result.
Placing Your Fill Dirt Order in Mission
- Put in the ton count from your estimate.
- Check the delivered total shown for the job address.
- Pay at checkout and file the confirmation with your project notes.
Clear the strip of driveway or lawn where the load will land before delivery day, and keep a rake and wheelbarrow close by.
About Fill Dirt
Fill dirt is a brown, earthen fill used to raise ground, fill low areas and bring a site up to grade. Each cubic yard weighs about 2,200 pounds, so the material is dense and settles into a firm base once it has been spread and wetted.
Gardeners and builders in South Texas reach for it when a lot needs more height than topsoil can supply on its own. Its job is structural: it fills the bulk of the space, and the finish material on top supplies whatever the surface needs to look or perform like the rest of the yard. Expect it to behave like a heavy, natural earth rather than a loose, screened product.
What Fill Dirt costs in Mission
In the Mission market, fill dirt is sold by the ton and priced at the gate before delivery is added on. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. One ton covers about 98 sq ft at a 3 inch finished depth, so a 400 sq ft driveway pad runs roughly 5 tons.
How crews use Fill Dirt in Mission
Crews working out of Mission tend to call for fill dirt on a few repeat jobs each week. The first is erosion control, typically laid in tight urban lots and infill builds with a base lift compacted before the finish course goes on. The second is driveway gravel, which lands here in dense neighborhoods where curb access is short and usually ships as a 4 to 8 ton order. With a population around 88,574, Mission pulls a mix of single-truck homeowner orders and contractor full-loads through the season.
Delivery day in Mission
On the day of the drop, the dispatcher pulls the closest yard, batches your ticket with other Mission stops, and sends a window the night before. Tandem-axle dumps need at least 12 ft of clear width and 14 ft overhead to set the bed; tri-axles need 14 ft of clearance on both counts and a level pad to tip safely. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.
Related materials we deliver in Mission
Price by ZIP- SizeScreened, no size grade
- Density2200 lb/yd³
- ColorDark brown
Price by ZIP- Density2000 lb/yd³
- ColorDark brown
Price by ZIP- Density1000 lb/yd³
- ColorDark brown
Estimate how much you need
Work out your material
A planning figure, not a guarantee. Order roughly a tenth extra to cover settling and uneven ground.
Browse more
Available in nearby cities
Plan your project
Related guides
GUIDEHow Deep Should a Gravel Driveway Be? Layer GuidePractical, field-tested guide: how deep should gravel driveway be. Pulled from real US installer notes and 2026 supplier price data.Read guide →
GUIDEHow Much Does River Rock Cost? By Ton or YardRiver rock cost depends on your ZIP code, order size, and whether you buy by the ton or the cubic yard. Here is how pricing works.Read guide →
GUIDEWhat Size Crushed Stone Goes Under a Concrete SlabMost slabs need 4 to 6 inches of compacted crushed stone underneath. What size crushed stone under a concrete slab needs, and why it matters.Read guide →
GUIDEWhat Is Crushed Stone? Sizes, Uses and Buying BasicsCrushed stone is quarried rock crushed and screened into angular pieces sold by the ton. Here is what it is, how it is graded, and where to use it.Read guide →Frequently Asked Questions
How do I keep heavy Valley rain from washing new fill away?
Shape the surface with a slight slope and cover it quickly with sod, seed or mulch. A row of stakes with a board or a line of stone along the low edge catches runoff while the cover takes hold. After the first hard rain, walk the area and rake any gullies flat before they deepen.
Can I raise a lot that sits lower than the alley or my neighbor?
Yes, but plan where the water will go once the ground is higher. Keep the fill inside your own line, hold it back from fences and walls, and slope the surface toward a spot that drains. Raising only your side can push runoff onto a neighbor, so check the flow after the first rain.
Will grass grow well on new fill in a warm climate?
Grass grows quickly in warm weather, but raw fill is thin on nutrients and can sprout weeds from seeds in the soil. Rake the surface fine, add a layer of planting soil, and water often until the new grass roots. Keep foot traffic off the area while it establishes.
Can I order for a job in McAllen or Pharr?
Enter the ZIP of the job address on the order page. The delivered price shown applies to that ZIP, not to Mission. McAllen is about 6 miles from Mission and Pharr about 9 miles, but the number on the page for each address is the one that counts, so check each job separately.
Should I water fill after I spread it?
A light watering settles the surface and shows low spots early, but soaking it turns the fill to mud. Water in short passes, let it drain, then rake the dips level. Do the first watering before you plant or lay sod, so any settling happens before the cover goes down.
Can I pile fill dirt around a tree?
Keep fill off the trunk and away from the root flare, since soil piled against the bark invites rot. A thin layer over the roots is usually tolerated, but a deep pile can smother them. For a tree you want to keep, build a low ring of stone or timber so the old soil level stays as it was.
Will fill dirt bring weeds into my yard?
It can. Fill is not screened for weed seed, so some sprouts may appear in the first weeks. Pull them young, and cover the area with sod, seed or mulch so they have less room. A layer of finish soil on top gives desired plants the head start over the weeds.
How can I tell where the old ground level was after the fill goes down?
Set stakes at the corners before the load arrives and mark the old grade on each one with tape. After spreading, measure from the tape to the new surface. That gives you the true depth of the layer in several spots, which makes any later top-up easy to size.