Fill Dirt Delivery in Jersey City, NJ

Fill dirt delivery in Jersey City, NJ comes down to a tight lot, a narrow street and a pile that has to land in the right place. MyGravelBuddy sells fill dirt by the ton, brings it to your address, and shows the delivered price for your ZIP before you commit. Orders start at 2 tons.

Fill Dirt here is the brown, unscreened sub-soil you use to raise grade and fill voids, not the dark topsoil you plant in. For the wider picture across the state, see Fill Dirt in New Jersey.

Why Jersey City yards call for fill dirt

With about 300,000 residents packed between the Hudson waterfront and the Hackensack side, most jobs in the city are small and awkward. A backyard in a rowhouse block might need a few tons to level a sunken patch, while a contractor next door is backfilling a trench or a retaining wall. Both are the kind of work fill dirt handles well.

Typical Jersey City jobs include:

• Raising a low back yard so water runs toward the street instead of the foundation
• Backfilling behind a new retaining wall or around a cellar-door replacement
• Filling a trench after utility or drain work
• Building a stable base ahead of a shed pad or a paver patio
• Bringing a sunken planting bed back up to level before topsoil goes on

Fill dirt delivery in Jersey City, NJ: planning the drop

Space decides most orders here. Look at the curb, the width of the gate or alley, and any overhead wires before you order, then tell the driver where the pile should go. A load dumped on the street side of a fence means a lot of wheelbarrow work, so a clear spot close to the job saves more time than anything else you can do, and it keeps the crew from carrying soil twice.

Street parking rules and permits for a pile left on public property are set by the city, so check them if the only open space is the curb.

The page for delivery in Jersey City explains how drop-off works for the area in more detail.

How much fill dirt you need

Measure the area in feet, decide on a depth, and convert: length times width times depth in inches, divided by 324, gives cubic yards. Fill dirt in this catalog is sold by the ton, and the data for this product puts a cubic yard at roughly 2,200 lb, so a yard is a little over a ton. Multiply your cubic yards by 1.1 for a working tonnage.

The calculator can run the Jersey City numbers for you if you would rather not work them out by hand. Add a modest margin on top of the result, because fresh soil packs down once it is wetted and walked on. Small city lots rarely allow a second delivery to be squeezed in, so it is cheaper to round up once than to reorder.

Pricing, ZIP by ZIP

There is no price list to decode. Enter your ZIP in the price box on the product page and the delivered price for that address appears, calculated live. Larger orders get a lower rate per ton, so combining a few small jobs into one order often beats ordering them separately.

In Jersey City, the smallest load you can book is 2 tons.

Other materials for the same job

Fill dirt rarely works alone. A drainage trench usually wants clean stone on top of the soil, and #57 Crushed Stone is the common choice for that. For a temporary parking pad or a rough access lane, Asphalt Millings compact into a firm surface. Pea Gravel and River Rock are also available in the city if the finished surface is decorative.

Ordering for a Jersey City address

Check out once the tonnage looks right for your ZIP. Contractors with sites beyond Jersey City can also order for Newark, Elizabeth and Paterson, which sit 8, 9 and 14 miles away, with each address entered on its own order.

About Fill Dirt

Fill dirt is brown, unscreened sub-soil dug from excavation sites and sold for raising grade, filling low spots and building up the ground under hard surfaces. It is not graded like topsoil, so expect a mix of clay, silt and sand with the occasional small stone.

It is sold here by the ton, and a cubic yard weighs about 2,200 lb. That makes it a good fit for backfilling trenches, leveling a yard, bringing a foundation perimeter up to grade and preparing a base before stone or pavers go down. Spread it in thin layers and compact each one for the firmest result.

Because it is not a growing medium, plan on a layer of topsoil over it where you want grass or beds. Fill dirt for Jersey City shows its delivered price for your ZIP on this page, and bigger orders get a lower rate per ton. Every order starts at 2 tons.

What Fill Dirt costs in Jersey City

In the Jersey City market, fill dirt is sold by the ton and priced at the gate before delivery is added on. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. One ton covers about 98 sq ft at a 3 inch finished depth, so a 400 sq ft driveway pad runs roughly 5 tons.

How crews use Fill Dirt in Jersey City

Crews working out of Jersey City tend to call for fill dirt on a few repeat jobs each week. The first is erosion control, typically laid in tight urban lots and infill builds with a base lift compacted before the finish course goes on. The second is driveway gravel, which lands here in dense neighborhoods where curb access is short and usually ships as a 4 to 8 ton order. With a population around 302,824, Jersey City pulls a mix of single-truck homeowner orders and contractor full-loads through the season.

Delivery day in Jersey City

On the day of the drop, the dispatcher pulls the closest yard, batches your ticket with other Jersey City stops, and sends a window the night before. Tandem-axle dumps need at least 12 ft of clear width and 14 ft overhead to set the bed; tri-axles need 14 ft of clearance on both counts and a level pad to tip safely. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

Estimate how much you need