Fill Dirt Delivery in Inglewood, CA, Priced by the Ton

Fill dirt delivery in Inglewood, CA is mostly a planning question, since tight street frontage and narrow side yards decide where a truck can stop. Inglewood has about 103,000 residents in Los Angeles County, and many fill jobs here are side yards, rear lots and driveway aprons that need to rise a few inches to shed water.

Choosing a drop spot on an Inglewood lot

Before you order, walk the route from the curb to the work area and measure the narrowest gate or side passage. Look for overhead lines, parked cars and any slope that could make the truck bog down. A clear spot close to the project matters more on a tight lot than on a large parcel.

Plan the wheelbarrow route in advance, since moving fill by hand across a long lawn is slow work.

Pricing for Inglewood fill orders

Orders go by the ton, with 2 tons as the minimum. Larger orders get a lower rate per ton, so combining a backyard grade and a front walkway into one order can make sense when both are on the same plan. The total for your ZIP is worked out live and appears on this page before you pay.

How much fill your Inglewood project needs

Take length and width in feet, multiply by depth in inches, and divide the product by 324 to reach cubic yards. The calculator can check that result against a tonnage. Each cubic yard of this fill carries roughly 2,200 pounds, which means a ton stretches to about nine tenths of a yard.

Allow extra depth for settling, since fill sinks as it dries and takes foot traffic. A surface that has to stay flat next to a sidewalk needs that allowance more than a rough backyard dip does.

Best uses for fill dirt in Inglewood

• Rear yard dips: a few tons can lift a shallow low spot where water pools after the rain.
• Driveway apron edges: raising the edge helps water run off the drive instead of across it.
• Utility trenches: once the pipe or conduit is in, fill closes the cut at surface level.
• Raised planting strips: fill builds the height of a strip along a wall or fence.

Where a patio sits lower than the yard around it, fill can bring the surrounding grade up to the edge so water drains away from the slab instead of pooling against it.

A patio or walkway base usually sits on #57 Crushed Stone, which drains better than fill, so keep fill below the base rather than using it as the base itself. Asphalt Millings can work for a temporary drive, but choose the material by how it will be used.

For a drainage path, Pea Gravel is a common choice because it moves water and holds a clean edge.

Grade, drainage and weather in Inglewood

Pitch the finished surface away from the house so water has a clear path toward open ground. Winter rain in Los Angeles County arrives in short, heavy bursts, so a surface that looked fine in dry weather can pool at the first storm. Finish the grading in dry weather whenever you can.

Keep fill and mulch back from the curb and gutter line. A storm drain that picks up loose material can clog, and a clogged drain sends water back toward the house.

Getting fill to Inglewood and nearby towns

Orders are delivered to the address you enter at checkout. Glendale is about 15 miles away, Pasadena about 19 miles, El Monte about 20 miles, and Palmdale about 36 miles. For the city details, see delivery in Inglewood.

Ordering fill dirt in Inglewood

Choose the tonnage you need and go to checkout. The Fill Dirt in California hub gathers the material for the whole state if you want to compare other places.

About Fill Dirt

Fill dirt is bulk earth used to build height under a surface. Its mineral base and small amount of organic matter make it a foundation layer, not a planting medium.

Expect a brown color with some variation in texture, since the material is dug from the ground and is never perfectly uniform from one load to the next.

Fill is priced by the ton, which is 2,000 pounds. A cubic yard of this material runs about 2,200 pounds, so a ton lands a little short of a full yard, and that gap is worth knowing before you convert a plan drawn in cubic yards.

Once it is delivered, a loader, skid steer or wheelbarrow can move it into place. Loose fill is light enough to drift in wind, so keep the pile covered if it will wait for the crew.

The material supports other layers rather than replacing them. Compost, topsoil and garden soil carry the organic matter that plants need, so most yards use fill for the height and add a planting layer only in the spots where roots will grow.

What Fill Dirt costs in Inglewood

In the Inglewood market, fill dirt is sold by the ton and priced at the gate before delivery is added on. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. One ton covers about 98 sq ft at a 3 inch finished depth, so a 400 sq ft driveway pad runs roughly 5 tons.

How crews use Fill Dirt in Inglewood

Crews working out of Inglewood tend to call for fill dirt on a few repeat jobs each week. The first is erosion control, typically laid in tight urban lots and infill builds with a base lift compacted before the finish course goes on. The second is driveway gravel, which lands here in dense neighborhoods where curb access is short and usually ships as a 4 to 8 ton order. With a population around 102,774, Inglewood pulls a mix of single-truck homeowner orders and contractor full-loads through the season.

Delivery day in Inglewood

On the day of the drop, the dispatcher pulls the closest yard, batches your ticket with other Inglewood stops, and sends a window the night before. Tandem-axle dumps need at least 12 ft of clear width and 14 ft overhead to set the bed; tri-axles need 14 ft of clearance on both counts and a level pad to tip safely. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

Estimate how much you need