Fill Dirt Delivery in Arvada, CO by the Ton

Fill dirt delivery in Arvada, CO means a brown, unscreened soil sold by the ton and placed where the grade needs to change. Arvada is home to about 124,000 people and sits just northwest of Denver, and plenty of its yards have a low corner, a sloping side or a patch where a slab, patio or lawn needs a flatter base. Fill dirt is the bulk material for that work. This page explains where it fits, how to size an order, and how ordering works for an Arvada address.

Fill dirt delivery in Arvada, CO: the local picture

Arvada's neighbors are close enough to share the same kind of yard work. Westminster is about 5 miles away, Lakewood about 6, Denver about 7 and Thornton about 9, and Aurora sits roughly 16 miles off. Most grading and backfill jobs in those cities need the same thing: a bulk material that packs firm and can be used in volume.

Because Arvada sits inside the Denver metro, many homeowners here also compare fill dirt with other bulk materials. The question to answer first is whether the job needs height, drainage or a planting surface, since each points to a different material.

Older Arvada neighborhoods often have yards that were graded decades ago, so a settled back corner is a common reason people start looking for fill. Newer builds have the opposite problem more often, with a house pad that sits above the street and needs the side yard brought up to meet it.

Where Arvada projects use fill dirt

Fill dirt shows up on a handful of recurring jobs in Arvada:

• Backfill: refilling a trench after a utility line goes in, or closing up the gap beside a foundation wall.
• Low corners: bringing a sunken part of the yard up to the surrounding grade so rain stops collecting there.
• Building pads: raising and leveling the ground under a shed, a garage slab or a patio before the base layer goes down.
• Lawn base: a rough layer underneath, finished with Premium Screened Topsoil where grass or beds will grow.

Fill also suits a fence line that has sunk, a raised bed base, or a driveway edge that needs building up before gravel goes on top. In each case the fill is the layer that brings the surface to height, and whatever goes on top is a separate choice.

How much fill dirt you need in Arvada

Multiply the length in feet by the width in feet, then by the depth in inches, and divide the result by 324. In Arvada, that math returns the volume in cubic yards. A 20 by 30 foot area filled 4 inches deep comes to about 7.4 cubic yards.

This material weighs about 2,200 lb per cubic yard, so 7.4 yards comes to roughly 16,300 lb. A ton is 2,000 lb, so that load is about 8 tons.

Fill settles as it is watered and walked on, so add about 10 percent to the number before you order. To check the numbers in one step, use the calculator.

Pricing notes for Arvada orders

Fill dirt is sold by the ton. The delivered price for your Arvada ZIP is calculated live and shown on the order page, and larger orders get a lower rate per ton. The smallest order is 2 tons, which suits a small repair or a short run of backfill.

Drainage and slope in Arvada yards

Fill should carry rain away from the house, not toward it. A common target is at least 6 inches of fall over the first 10 feet from the foundation. Where water still has to cross the fill and drain fast, Pea Gravel is a better top layer than soil, because it sheds water instead of holding it.

Ordering fill dirt for an Arvada address

Pick a dry stretch of weather for the delivery, since wet fill is heavy to spread and hard to pack. Confirm the tonnage and the ZIP on the order page before you commit.

The delivery in Arvada page covers the city details, and the Fill Dirt in Colorado page covers the state as a whole. With the tonnage and the ZIP price in hand, you can settle on the order size with confidence.

About Fill Dirt

About this material

Fill dirt is an unscreened brown soil sold by the ton. Because it is not run through a screen, the mix carries a range of particle sizes, from fine soil to small stones and some clay. That range is what lets it pack firm under a load, which is the main reason crews choose it for bulk work.

A ton is 2,000 lb. This material weighs about 2,200 lb per cubic yard, so one cubic yard comes out to a little over a ton. Plan orders in tons, since that is the unit the order page uses.

The material is built for the bulk layers of a grade change: raising ground, filling a trench, or setting a level base before a slab or paver run. It is not a planting medium, so a finish layer goes on top wherever grass or flowers will grow.

What Fill Dirt costs in Arvada

Local Arvada yards quote fill dirt by the ton; the delivered number includes fuel, the truck, and the haul. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. A ton of this material spreads across about 98 sq ft when laid 3 inches deep, useful when you are sizing a patio base or a walkway run.

How crews use Fill Dirt in Arvada

In and around Arvada, fill dirt shows up most often on two project types. The most common deployment is erosion control, often in tight urban lots and infill builds in two to three inch lifts. Second on the list is driveway gravel, which we see in dense neighborhoods where curb access is short on partial-truck deliveries. At roughly 124,402 people, the Arvada order mix leans toward 3 to 8 ton residential drops with the occasional 16 ton job for a contractor.

Delivery day in Arvada

A typical Arvada drop is dispatched from the closest yard with a two hour window and a heads-up call once the truck is loaded. Tandem trucks want a 12 ft lane in and out; tri-axles need 14 ft, and both want firm ground at the tipping spot so the load releases cleanly. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

Estimate how much you need