Fill Dirt Delivery in Fort Collins, CO by the Ton
Fill Dirt · Fort Collins, CO

Fill Dirt Delivery in Fort Collins, CO by the Ton

Bulk fill dirt delivered in Fort Collins, CO. Brown color.

Starting from $491.08 delivered to Fort Collins for 2 tons, our minimum order

Weight per yard 2200 lb Density 81.5 lb/cu ft

Fill dirt delivery in Fort Collins, CO means brown, compactable subsoil sold by the ton and dropped at your address. A city of about 170,000 people keeps a steady stream of yards, foundations and small lots that need soil brought in, and this page covers how to size, order and use it. Neighbors in Greeley, about 26 miles away, and Boulder, about 41 miles away, order the same way from their own pages.

Fill dirt delivery in Fort Collins: what the material is for

Fill dirt is subsoil meant for building up and leveling ground, not for growing plants. It packs down firmly under a plate compactor, which is why it goes under things that must not sink. Common Fort Collins jobs include:

Planting beds are a different job and call for Premium Screened Topsoil. A walkway or garden path that sits on compacted fill can be topped with Pea Gravel, which is also sold by the ton. The Fill Dirt in Colorado page lists every city we serve.

How much fill dirt to order

A cubic yard of fill dirt weighs roughly 2,200 lb, a bit over a ton, so one ton covers a little less than a cubic yard. Take a lot that is 20 feet by 15 feet and needs 6 inches of fill: multiply 20 by 15 by 6, divide by 324, and you land near 5.6 cubic yards, or about 6 tons. If your yard is uneven, run the numbers in the calculator for each low area and add them up.

Fresh fill settles after it is placed and rolled. Adding 10 to 15 percent to your total gives you enough to top off the low spots once the soil has packed down.

Getting it delivered to your lot

Everything shipped to the city runs through our delivery in Fort Collins page, which shows what is available at your address. Before the truck arrives, pick a drop spot on firm, level ground with open room overhead and a clear path from the street. Fill is dumped in a single pile, so a driveway, an alley or a flat corner of the lot works better than a lawn or a soft shoulder. A wheelbarrow or skid steer moves it from there.

Lots with narrow gates, low branches or power lines near the drop spot should be flagged when you order so the pile ends up where it can be reached.

Spreading and finishing the job

Once the pile is down, work from the far end of the area back toward the pile so you never drive over soil you have just leveled. A landscape rake pulls the dirt into place, and a long straightedge shows high and low spots before the compactor goes over it. Do the edges by hand where a machine will not reach, such as beside a wall or tight against a slab. When the fill is firm underfoot and holds a footprint without squishing, it is ready for the next layer.

Other materials in the city come in handy on the same project. River Rock works for drainage borders and dry creek beds, and #57 Crushed Stone makes a stable base where a slab or pavers will sit over the fill. Each is priced by the ton from its own page.

Pricing and how to order

Fill dirt is sold by the ton, and the smallest order is 2 tons. The delivered price is calculated live and shown for your ZIP, so the number you see already reflects the haul to your door. Larger orders get a lower rate per ton, which is worth remembering if a neighbor is also regrading and you can order together.

To order, enter your ZIP on this page, choose the number of tons and check out. Compare your total against the measurements above before you confirm.

About Fill Dirt

Fill dirt is a brown, unscreened subsoil used wherever ground has to be raised, leveled or backfilled. It is dug from below the topsoil layer, so it carries little organic matter and does not rot away and shrink the way planting soil can. That makes it a dependable base under slabs, pavers, sheds and retaining walls once it has been compacted in layers.

The soil is a natural mix of clay, silt, sand and small stones, so each load looks a little different. It is not screened for appearance, and it is not meant for flower beds, vegetable gardens or lawns without a topsoil layer on top. What it does well is hold a shape and carry weight, and it packs tight when it is slightly damp.

A cubic yard weighs around 2,200 lb, a little over a ton, and the material is sold by the ton. Fort Collins fill dirt is priced for your ZIP on the page, and bigger loads drop to a lower rate per ton. For Fort Collins jobs, the smallest fill dirt order is 2 tons.

What Fill Dirt costs in Fort Collins

In the Fort Collins market, fill dirt is sold by the ton and priced at the gate before delivery is added on. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. One ton covers about 98 sq ft at a 3 inch finished depth, so a 400 sq ft driveway pad runs roughly 5 tons.

How crews use Fill Dirt in Fort Collins

Crews working out of Fort Collins tend to call for fill dirt on a few repeat jobs each week. The first is erosion control, typically laid in tight urban lots and infill builds with a base lift compacted before the finish course goes on. The second is driveway gravel, which lands here in dense neighborhoods where curb access is short and usually ships as a 4 to 8 ton order. With a population around 169,810, Fort Collins pulls a mix of single-truck homeowner orders and contractor full-loads through the season.

Delivery day in Fort Collins

On the day of the drop, the dispatcher pulls the closest yard, batches your ticket with other Fort Collins stops, and sends a window the night before. Tandem-axle dumps need at least 12 ft of clear width and 14 ft overhead to set the bed; tri-axles need 14 ft of clearance on both counts and a level pad to tip safely. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

SAME CATEGORY

Related materials we deliver in Fort Collins

Estimate how much you need

Work out your material

Cubic yards0 cu yds
Approximate weight0 tons

A planning figure, not a guarantee. Order roughly a tenth extra to cover settling and uneven ground.

PRODUCT & CITY HUBS

Browse more

PROJECTS

Common uses for Fill Dirt in Fort Collins

NEARBY

Available in nearby cities

TOOLS

Plan your project

KEEP READING

Related guides

Frequently Asked Questions

What should I do with leftover fill dirt?

Leftover soil is easy to use up. Pile it where a low spot has settled, fill ruts left by the truck or a wheelbarrow, or bank it against a retaining wall that needs more backfill. Fill keeps well as a pile, so there is no rush, but spread it before weeds take hold on top.

Can I plant grass straight onto fill dirt?

You can, but results are usually thin and patchy because subsoil holds few nutrients. Spread a layer of topsoil, about 3 to 4 inches, over the compacted fill before seeding or laying sod. The grass roots into the richer layer while the fill below stays firm and stable.

How do I compact fill dirt properly?

Spread the dirt in layers about 6 inches thick and compact each layer before adding the next. Slightly damp soil packs best, while dust-dry or soaked soil resists. A rented plate compactor handles small areas, and a roller suits larger pads. Skipping layers leaves soft pockets that settle later.

Can I order only one ton?

No, the smallest order is 2 tons. That still goes a long way on a small repair: 2 tons covers roughly 290 square feet at a depth of 2 inches. If you only need a bucket or two for a hole, a bagged product from a garden center is the better fit.

Will the dirt contain rocks or debris?

Fill dirt is unscreened subsoil, so expect some small stones, clumps and clay along with the soil. That is normal and is part of why it compacts so well. If you need fine, clean soil for beds or lawns, choose a screened product instead of fill.

Is fill dirt suitable under a concrete slab?

Compacted fill is commonly used to raise and level the ground under slabs, but the specification is set by your plans or local code. Ask your engineer, builder or the city building office for the compaction requirement, and add a layer of crushed stone on top if the slab design calls for one.

How do I protect the pile if rain is coming?

Cover the pile with a tarp and weigh the edges down so runoff does not carry soil into the street or a storm drain. Move the dirt into place soon after the drop, because a spread and compacted surface sheds water far better than a loose heap.

How do I measure depth on an uneven yard?

Drive a stake at the high point, string a level line across, and measure down to the soil at several spots. Average those readings for your depth, then multiply by the length and width of the area.

Order Fill Dirt →
0
    0
    Your Cart
    Your cart is emptyReturn to Shop