Fill Dirt Delivery to Abilene, TX Addresses
Fill Dirt · Abilene, TX

Fill Dirt Delivery to Abilene, TX Addresses

Bulk fill dirt delivered in Abilene, TX. Brown color.

Starting from $478.10 delivered to Abilene for 2 tons, our minimum order

Weight per yard 2200 lb Density 81.5 lb/cu ft

Homeowners and small contractors in Abilene usually look into fill dirt delivery for one of three reasons: a low corner that holds water, a raised bed that needs more soil underneath, or a pad that has to come up before a shed or slab goes down. This page covers how an order for fill dirt delivery in Abilene, TX works, which jobs the material suits, and how to size the load before you buy.

Ground conditions around Abilene

Abilene sits on the Rolling Plains of West Texas, where summers run hot and dry and the soil often changes within a short distance. Many lots carry a thin layer of topsoil over clay, and in places a pale limestone layer called caliche sits within a few feet of the surface. Dig into that and you tend to hit hard, chalky material instead of soft ground, so a yard that looks level from the street may still need fill before it drains well or supports a structure.

The city is home to about 125,000 people, and the lots range from older blocks to newer subdivisions. Two houses on the same street can sit on very different ground, so check the spot you plan to fill rather than assuming the next lot matches yours.

Best uses for fill dirt delivery in Abilene, TX

Fill dirt does its best work where you need bulk: raising a low corner, building up ground under a future patio, or backfilling a trench once the pipe is in. It adds height and mass, but it is not a finished surface. If the top layer is for planting, a bed of Premium Screened Topsoil over the fill gives roots better material to work in.

Where water needs a path out, many Abilene owners pair the fill with Pea Gravel for drainage paths and dry creek beds. The fill does the lifting and the gravel does the carrying, which is a useful split when the goal is to move rain away from a structure.

How much fill dirt to order

Measure the area in feet and the depth in inches. For an Abilene dip, multiply length by width by depth, then divide by 324 to get cubic yards. A 20 by 15 foot area filled 6 inches deep comes to about 5.6 cubic yards, or roughly 6.1 tons at about 2,200 pounds per cubic yard. Measure at the lowest point of a dip rather than the average, because the deepest spot sets how much material the whole area needs. Fill also settles after it is placed and worked, so add a small margin when the finished grade matters, such as under a slab or a walkway.

If you would rather skip the arithmetic, the calculator gives a quick estimate from the same measurements before you place the order.

What the price looks like for Abilene addresses

Fill dirt is sold by the ton, and the smallest order is 2 tons. The delivered price is calculated live and shown for your ZIP before you order, so the figure on screen already includes the drop at your address. Larger orders get a lower rate per ton, which makes a full side yard or a multi-bed project easier to justify than a single small patch.

Ordering and choosing the drop spot

Pick the drop spot before the truck arrives. Choose a firm, flat surface the load can reach without crossing soft lawn, and check the route for low branches, power lines, a narrow gate or a tight turn. Clear tools, bins and parked vehicles out of the way. If the material has to travel far from the drop to the fill area, plan for a wheelbarrow crew or a helper, because a pile in the wrong place costs more time than a few extra feet of driveway would. For the delivery side of an Abilene order, see delivery in Abilene. For other Texas towns, see Fill Dirt in Texas.

Shaping, drainage and timing

Finish the fill so it falls away from the house at a steady slope rather than pooling in the middle. Abilene storms can arrive in heavy bursts, so avoid placing fill on ground that is already saturated, and spread it while the surface is dry enough to work. A few minutes of raking after the load is down will show where water would stand, and that is the place to add material before the next rain.

About Fill Dirt

Fill dirt is mineral soil moved from one place to another to bring a low or uneven area up to grade. It is mostly subsoil, so it carries little organic matter and suits building height and bulk more than growing plants. The color runs brown, and the material is sold by the ton.

Weight is the figure to keep in mind when you plan a drop. Fill dirt weighs about 2,200 pounds per cubic yard, so a ton covers a little less than one cubic yard of loose material. That is far too heavy to move by shovel and wheelbarrow in any quantity, which is why most homeowners choose a truck drop over hauling bags.

The material is useful for a range of ground work. Common jobs include raising a sunken spot near a driveway edge, adding height along a retaining wall, and shaping a berm for privacy or runoff control. Once it is on site it spreads with a rake and a shovel, so one drop can be worked into a large area across a weekend.

What Fill Dirt costs in Abilene

Around Abilene, fill dirt is quoted by the ton with delivery layered in based on distance from the closest yard. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. Plan on roughly 98 sq ft of coverage per ton at 3 inches deep, which puts a single-car driveway in the 4 to 7 ton bracket.

How crews use Fill Dirt in Abilene

Abilene contractors keep fill dirt on the order sheet for a short list of standard installs. Top of the list is erosion control, where the material is rolled out in tight urban lots and infill builds and screeded to grade. Right behind that is driveway gravel, common in dense neighborhoods where curb access is short and often paired with edging or fabric below the lift. Abilene sits at about 125,182 residents, which means we see steady weekday traffic from landscape crews and weekend pickups from owner-builders.

Delivery day in Abilene

Delivery in Abilene runs out of the nearest pit; you get a two hour arrival window the evening prior and a call when the driver leaves the scale. Plan for 12 ft of clear path for a tandem and 14 ft for a tri-axle, plus a level area at the dump point so the bed lifts straight. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

SAME CATEGORY

Related materials we deliver in Abilene

Estimate how much you need

Work out your material

Cubic yards0 cu yds
Approximate weight0 tons

A planning figure, not a guarantee. Order roughly a tenth extra to cover settling and uneven ground.

PRODUCT & CITY HUBS

Browse more

NEARBY

Available in nearby cities

TOOLS

Plan your project

KEEP READING

Related guides

Frequently Asked Questions

Can fill dirt go into a vegetable garden?

Fill is mostly subsoil with little organic matter, so it does not feed plants well on its own. A county extension office can test a sample from the top few inches of the bed and report pH and nutrient levels. Leafy greens and herbs tolerate poorer ground better than deep-rooted crops, so test first, then choose what to grow based on the results.

Can I put fill dirt under a concrete slab?

Often yes, but the rules depend on your city and the size of the slab. Many projects need the fill placed in layers and firmed as it goes. A local permit office or a contractor who pulls permits in your area can tell you the required depth and any testing. Ask before the truck arrives so the drop lands where the work can start.

Will grass grow in straight fill dirt?

It can, but timing matters in Abilene heat. Seed is cheaper but needs steady moisture through hot weeks, so many owners sow in a cooler season. Sod roots faster and forgives a late start if it is watered daily. Rake the surface smooth first, and keep foot traffic off until the grass has taken hold.

How do I tell whether I need fill or a drainage fix?

If water stands in a dip only after heavy rain and drains away within a day, fill may solve it. If water sits for days or seeps back up from below, the cause is more likely a high water table or a broken drain, and more fill can make it worse. Dig a test hole about two feet deep and check it after a rain before you order.

Who needs to be home when the fill arrives?

Someone who knows the drop spot and the job should be on site. The driver needs a clear place to unload and someone to confirm where the material should go. If nobody can be home, leave a note at the gate or send a photo of the drop area so the driver knows where to go and what to avoid.

What do I do with leftover fill?

Spread the extra in a low area of the yard, along a fence line, or in a planting bed you have been meaning to raise. Fill left in a pile tends to wash into the lawn, so shape it as you go. If you have a lot left over, a thin layer across the yard is usually easier than trying to store it.

Is fill dirt the same as clay?

Not exactly. Clay is a fine-grained soil type, and fill can contain clay, sand, silt or a blend, depending on where it was dug. What matters for your project is how the material drains and packs. Clay-heavy material holds water and drains slowly, which matters in Abilene where caliche and clay already limit drainage.

What should I check in the load before I accept it?

Look for debris such as wood scraps, plastic, roofing pieces and large rocks. Clean fill should look like soil, not a mix of trash. Ask the seller what the material is and where it was dug. If something looks wrong, say so before the driver unloads, since fill left on the lawn is hard to clean up.

Order Fill Dirt →
0
    0
    Your Cart
    Your cart is emptyReturn to Shop