Fill Dirt Delivery in Kirkland, WA by the Ton

Fill dirt delivery in Kirkland, WA suits grading jobs, backfill around a new foundation, and raising a low corner of the yard. Kirkland is a lakeside city in King County, and many lots have enough slope that grade changes come up often.

Fill Dirt Delivery in Kirkland, WA for Grading and Backfill

Most Kirkland orders go toward regrading a side yard, filling a depression beside a driveway, or backfilling a trench for a utility line. Leveling a shed pad or building up a low corner before a patio goes in are also common jobs. Fill dirt works for gentle grade changes where a full retaining wall would be more than the job needs.

Wet winters are the main timing concern. Saturated ground is hard to spread and shape, so schedule the work for a dry stretch when you can.

Drainage comes next. The finished surface should pitch away from the house so rain runs off instead of collecting at the foundation.

Trench backfill

Backfill a utility trench in stages and keep large clumps out of the first layers, since they leave voids that shift later around the pipe. Finish the top with material that matches the ground beside it so the repair does not show as a stripe across the lawn.

Shed pad

A shed pad has to be level from one side to the other, not just high in the middle. Check the layout with a long straightedge and a level before the material goes down, and mark the corners so the pad matches the floor plan you intend to set.

Low corner of the yard

A corner that collects runoff often needs more than a layer of fill. Work out where the water arrives from, whether a roof valley, a downspout or a neighbor's grade, and redirect it before you raise the low point.

How Much Fill Dirt Your Project Needs

Take a Kirkland side yard that runs 30 feet long and 8 feet wide and needs 4 inches of fill. Multiplying 30 by 8 by 4 gives 960, and 960 divided by 324 comes to about 3 cubic yards. Measure the lowest and highest points of your own area as well, because one average depth can hide a deep dip beside a level section.

Add a little extra for settling, since fill that is spread and tamped will sink somewhat over the following months. Fill runs about 1.1 tons to the cubic yard, so that side yard would call for roughly 3.3 tons before the settling allowance.

The calculator on this site can help you check the arithmetic before you order.

Delivery Access and Nearby Cities

Choose a flat spot near the work area that the truck can reach without backing down a long, narrow drive. Check overhead branches, gate widths and soft lawn edges before you place the order, because a tight approach makes a simple drop harder than it should be. If the spot sits behind a gate, open it before the truck arrives and leave a clear path back out.

From Kirkland, Bothell is about 5 miles away, Shoreline about 8 miles, Seattle about 9 miles, Bellevue about 12 miles, and Redmond about 13 miles. For city-specific delivery details, see delivery in Kirkland.

Pricing Notes for Kirkland Orders

Fill dirt is sold by the ton. The delivered price for your ZIP is calculated live and shown on the page, so the figure you see already covers the trip to your address.

The rate per ton drops as the quantity grows, so a full regrade of a Kirkland lot costs less per ton than a single small patch does.

If the regraded area will end up as lawn or garden bed, the finishing layers have their own units: Premium Screened Topsoil for the seedbed goes by the ton like this material, and Mulch for the planting beds goes by the cubic yard.

Ordering Fill Dirt in Kirkland, WA

Start from the Fill Dirt in Washington page if you want to compare how other cities are set up, then return here to enter your ZIP code. Work out the tonnage from your measurements, add it to your cart, and confirm the quantity before you check out. The smallest order is 2 tons, so a very small patch may still call for a two-ton order. Write down the tonnage, the drop address and the cart total in one note, so you can match them against the confirmation.

About Fill Dirt

Fill dirt is subsoil that gets moved from one site to another, mainly to raise a grade, fill a depression, or backfill a trench. It is usually brown and dense, and it holds its shape well once it is firm, which is why it suits structural grading better than planting.

The material has little organic matter and few of the nutrients roots need, so lawns and garden beds usually sit on a layer of topsoil is, so a load can include stones, pieces of root or clumps of clay. Most of that is harmless under a finish layer, but pick out the largest pieces before the surface goes down.

Because the material is sold by weight, the tonnage for a given job depends on how wet the load is and how tightly it packs once spread. Looking over the pile before you start spreading gives you a good read on how it will behave in the finished area.

What Fill Dirt costs in Kirkland

In the Kirkland market, fill dirt is sold by the ton and priced at the gate before delivery is added on. Send your ZIP and load size and we will send back a same-hour quote with the truck rate and the per-ton figure spelled out. One ton covers about 98 sq ft at a 3 inch finished depth, so a 400 sq ft driveway pad runs roughly 5 tons.

How crews use Fill Dirt in Kirkland

Crews working out of Kirkland tend to call for fill dirt on a few repeat jobs each week. The first is erosion control, typically laid in tight urban lots and infill builds with a base lift compacted before the finish course goes on. The second is driveway gravel, which lands here in dense neighborhoods where curb access is short and usually ships as a 4 to 8 ton order. With a population around 95,499, Kirkland pulls a mix of single-truck homeowner orders and contractor full-loads through the season.

Delivery day in Kirkland

On the day of the drop, the dispatcher pulls the closest yard, batches your ticket with other Kirkland stops, and sends a window the night before. Tandem-axle dumps need at least 12 ft of clear width and 14 ft overhead to set the bed; tri-axles need 14 ft of clearance on both counts and a level pad to tip safely. Standard lead time on this lane is Mon-Sat, with same-day windows held open for orders that hit the desk before 11 AM and clear payment.

Estimate how much you need